Section Widget
How to adjust Pinion angle
Helpful Video
http://www.youtube.com/watch?v=i8FNgaNqS8s
Measuring Pinion Angle
Pinion angle is the difference between the centerline of the driveshaft and the centerline of the pinion shaft of the differential. To measure it you must be able to work under the car with the suspension fully loaded and the car level. A drive-on lift works best for this.
Method "A" - (recommended)
http://i189.photobucket.com/albums/z...on_angle_a.gif
Method A (recommended)
Use an angle measuring gauge (adjustable protractor) to measure the difference between the pinion flange and the drive shaft directly. These gauges are available for under $10 from a hardware store. Place the edge of the gauge vertically against the front of the pinion flange, beside the driveshaft. Extend the measuring arm forward parallel to the bottom of the driveshaft. Extend a straight edge under the driveshaft to the measuring arm of the angle gauge. Hold the straight edge flat against the bottom of the driveshaft and adjust the measuring arm to read the angle. Depending on the gauge you use, you may have to subtract 90° from your reading to get the correct number. Your final measurement should be between 0 and 5. Examine the diagram at the bottom to determine if the pinion angle is nose up or nose down.
----------------------------------------------------------------------------------------------------------------------------------------------------
Method "B"
http://i189.photobucket.com/albums/z...on_angle_b.gif
Method B
1) Use a gravity angle gauge (Available at hardware stores) to measure the angle between the driveshaft and the ground. Hold the gauge on the bottom of the driveshaft. Align the gauge front-to-back under the car in line with the driveshaft and read the number from the gauge. Write down this number.
2) Next, hold the side of the gauge against the front of the pinion flange (beside the driveshaft). Measure the angle between the pinion shaft and the ground. Write down this number.
3) Subtract the first number from the second number. This is your pinion angle. Examine the diagram at the bottom to determine if the pinion angle is nose up or nose down.